Estimated installation time 20 minutes.
"Electrical Engineering degree not required"

(1).  Move the passenger seat all the way forward, and tilt the seat forward.

(2). Locate a 1.5" thick black wire loom behind and under the passenger seat.

(3). Carefully cut open the fabric tape around the loom to expose the wires.

(4). Find and isolate the (black wire with green strip).  Becareful not to cut the wrong wire, there is a green wire with black strip in the loom.

(5). Cut the black/green wire with a wire cutter and prepare the ends of the wire for the cramp connector.

(6). Cramp the 2 blue "plug in connectors" that came with the "Beep, Beep" kit to the ends of the black/green wire.  The male end of the blue connector is to be cramped to the black/green wire closest to the door side, and the female blue cramp connector is to be cramped on the black/green wire closest to the center console.

(7).  Unscrew the philips screw right behind the front passenger seat and secure the black wire with the "C" shaped connector from the 'Beep, Beep" underneath the screw, and tighten the screw.

(8). Plug in the two blue "plug in" connectors from the "Beep, Beep" unit to the newly cramped on blue connectors on the black/green wire you just made.  If you followed the direction correctly the wires can only go in one way. Male connectors have to match feamale connectors.  Peal off the plastic on the velcro of the "Beep,Beep" unit and place the unit on top of the silver factory alarm control box.

(9). Tape up the opening you made on the wiring loom with electrical tape and you are done.

(10).  Test the unit just like you would locking and unlocking your doors.