|
The factory twin turbo wing may look simple from the outside, but underneath it is compose of many unusual expensive parts and pieces. I was lucky enough to find a used factory twin turbo wing for sale, but unfortunately when it arrived I realized that it was missing all the mounting hardware, the inner grille and other parts and pieces. So I obtained a copy of the factory Porsche component break down sheet to see what parts and pieces are in the factory twin turbo tail. To my surprise the all the parts and pieces came out to $170, and the inner grille by itself was $320. Here is a list of the parts I purchased
This is a picture of the painted tail,
you will need to have the tail piece and the top grille painted the same
color as your car
Here are some of the parts and pieces to
complete the installation of the twin turbo tail (mounting bolts are not
in this picture)
Before mating the inner grille with the
top grille you will need to insert a total of 6 rubber sleeve on the edge
of the top grille.
Slide 4 mounting clips on each side of
the top grille
Mate the inner grille and the top grille
together
Insert the inner and outer grille into
the tail from the outside, and secure the grille with washer and bolts.
(total 4)
Cap off the grille mounting bolt opening
with these round plastic caps
Here is a picture of the grille secured
on the tail
Install the stopper on each side of the
tail
Install the center hinge
Install the deck lid edge rubber seal
|
