(1).  Need to jack to front of the car up, on how to jack the front of the car up please refer to "How to jack you car up" on the DIY section.

(2).  Unscrew the philips screw inside the front fender liner.

(3).  Unscrew the 3 philips screw underneath the panel.

(4).  Pull the front fender liner out to access the hidden bracket.

(5).  Pull the rubber piece out toward the front of the car to remove it from the bumper.

(6). Compare the Gt-2 splitter to the original factory part to get a good idea of where the mounting holes needs to be drilled.  The factory fender liner will also need to be modified in order for the Gt-2 pieces to fit correctly.  A square section of it needs to be cut off.

(7).  Once the GT-2 front splitter is mounted mark the holes that needs to be drilled and drill the holes for the factory screw to go back into.  The M.A. GT-2 kit does have some fit problem in the front center piece, the center piece is just not long enough for the screws to secure the tabs to the front splitter.  Later I will have to make my own tabs using fiber glass to make sure the front center section will not fall off during normal usage.

Back to aero kit DIY menu
Back to main DIY menu
p-car.com
Web master